|
|
#11
10-12-10, 13:01
|
||||
|
||||
Yes the everted edges of the locker orifice mate with the raised lid profile. This what you have identified.
Classic car body restoration suppliers have a range of hand operated bending gadgets which might do the fancy bits. For simple bends I have one of these. With care you can do a long run or dismantle for small pieces as it comprises 3 pieces of unequal lengths. Looks better than the vice marked metal on one piece & a "hammered effect" on the other! http://cgi.ebay.co.uk/150mm-SHEET-ME...item2c592c4d93
__________________
Clive Elliott GW4MBS (Old) South Wales UK 
|
|
|
Threaded Mode