|
|
#12
10-12-10, 13:30
|
||||
|
||||
Gadget
Thats a clever little impro for a bench vice! The only limitation would be sections only 150mm wide / long. Another option could be a small gauge angle profile that can be tack welded underneath as the angles can be purchased a small as 12x12mm or even 10x10mm / 3/8"x3/8".
I will end up doing some simple fabrication drawings as a master to fabricate from so will share these with you once they are done! Regards Wayne
__________________
Wayne 1959 Royal Ordnance FV1611A 
|
|
|
Threaded Mode