|
|
#34
19-06-17, 07:56
|
||||
|
||||
valves
I have new Morris 6 valves , got them from Cox & Turner years ago .
As an experiment, I had a go at refacing the worn and pitted exhaust valves that were taken out of the original CS8 motor. I used a 4 jaw chuck and a HSS tool in a lathe. A few very light cuts and a polish with emery cloth . These are not hard stellite valves that would normally need a grinder. The refaced valves are good enough to use again but I will be using the new valves because they have more " meat" on them.
__________________
1940 cab 11 C8 1940 Morris-Commercial PU 1941 Morris-Commercial CS8 1940 Chev. 15cwt GS Van ( Aust.) 1942-45 Jeep salad 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| So my employer wants me to restore this. | Sean Dunnage | The Softskin Forum | 13 | 18-07-14 17:48 |
| Two T16s to restore | EricF | The Carrier Forum | 16 | 17-02-13 19:40 |
| Wanted, WC51 or 52 to restore | Eric Szalanda | For Sale Or Wanted | 1 | 01-06-10 18:41 |
| Help wanted to restore C8A | Hanno Spoelstra | The Restoration Forum | 1 | 20-09-09 11:48 |
| Question about CMP to restore in Argentina | Hanno Spoelstra | The Restoration Forum | 3 | 23-06-09 10:45 |
Threaded Mode