|
|
#11
24-09-21, 17:50
|
||||
|
||||
Glad no real damage was done to the radiator. I echo what Rob says about Loctite. That should keep the bolts from backing off. I think your other alternative will be constant pretrip inspection of them to make sure everything is tight before hand.
As for the wobble. Do your steering knuckles use the New Departure pivot bearing with shims? Going by some of your pictures the basic steering knuckles look very similar to the CMP ones. Is there any side to side play on the wheels if you jack up the front of Lynx? When I rebuilt my truck I was sure to follow the step by step instructions in he manual for getting these setup with the shims.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lynx Hull number? | James Gosling | The Armour Forum | 3 | 17-08-15 08:28 |
| At last here are some photos NZ LP hull | Lew Skelton | The Carrier Forum | 12 | 29-04-11 10:22 |
| Hull # | gary_bath_jr | The Carrier Forum | 5 | 12-07-10 20:31 |
| Welded hull | martyn | The Carrier Forum | 14 | 15-03-10 13:02 |
| UC Hull | Richard Coutts-Smith | The Carrier Forum | 14 | 08-04-08 01:25 |
Threaded Mode