|
|
#11
03-02-21, 12:20
|
|||
|
|||
I would have thought that the reason for raising the bumper was to get it further from the ground as the vehicle was to be used cross country. That would have required the starting handle hole to be in in the bumper rather than above it. There would have been no motivation to have the starting handle go through the bumper otherwise.
David 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 16" 8 bolt Split Rims for 1.5 ton Australian Chevrolet Trucks | Philippe Jeanneau | The Softskin Forum | 66 | 13-08-20 15:17 |
| Other Wheel Options for Early Chevrolet 1.5 ton Trucks... | Philippe Jeanneau | The Softskin Forum | 5 | 01-07-19 01:42 |
| 10 bolt Front Hubs for 1.5 ton Australian Chevrolet Trucks 1940-1945 | Philippe Jeanneau | The Softskin Forum | 0 | 31-03-19 17:13 |
| 1938 Chevrolet 15-cwt G/S trucks | David_Hayward (RIP) | The Softskin Forum | 9 | 15-09-06 02:44 |
| CC60L Chevrolet Modified Conventional Trucks | robbi7 | The Softskin Forum | 23 | 14-05-04 14:28 |
Threaded Mode