|
|
#30
17-01-18, 23:35
|
||||
|
||||
Mike, back on the first page of your post you had some great pictures of rebuilding your water pump. You replaced the original seals with a modern mechanical seal. I'm just wondering how it all turned out once it had been in use?
Is this the type of seal you used? https://www.grainger.com/product/PAC...aft-Seal-1R318 Thanks.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| For Sale: Morris Commercial Piston Liners | Andrew Rowe | For Sale Or Wanted | 0 | 24-09-14 09:23 |
| For Sale: piston-ring-pin: Chevrolet Canada/US | Dirk Leegwater (RIP) | For Sale Or Wanted | 0 | 29-08-12 16:48 |
| Make your own piston rings | Mike K | The Restoration Forum | 0 | 11-08-11 14:45 |
| Wanted: Piston for Chev Engine | Willanthry | For Sale Or Wanted | 21 | 15-07-09 14:40 |
| Piston Rings | ron | The Restoration Forum | 8 | 25-01-09 11:45 |
Threaded Mode