Wire-3 Fitted For Wireless Box details

[Jordan Baker]

Do you know what the distance between the holes on the terminal strips are? I'm wondering if they were mounted on the wood boards. If you look at post #9 drawing number 1 I've shown the wood board that is mounted to the top bows. The hole centres are 5" apart. Each side has two sets. That would give the truck 4 terminal strips. The wood boards acted as a lower frame for holding the top bows together when setup as a ground station. See the picture for the holes (with bolts/nuts) on the wood. You can also just make out the charging board on the extreme left.

The bottom angle brackets on the table were simply for mounting the table to the floor. Those knobs I was looking for pass through the angles and go into bolts welded on the underside of the floor.