Clutch rod assembly for mk1*

[charlie fitton]

standard pins and cotters on mine ( I think ).......

If all goes according to plan , I'll be pushing and pulling things about this afternoon and will look then. Maybe even make a photographic rendering.

I'd do a charcoal sketch but it's hard to mail a cave wall.

[charlie fitton]

Lets see how this goes: (from a carrier hull on its way to a new home...)


The tape was hooked over the end of the clevis as shown in pic 3...

from the bulkhead end , the first bend is at about 18"

the matching bend is at the rear clevis

total offset is about 2" and

of course the axis pins are parallel...