|
|
#7
30-04-12, 13:04
|
||||
|
||||
right. here are some pics from the underside hope they are ok
  the countersink cutter i used was a Maykestag cobalt cutter 16.5 x 90 i use a slow speed drill and drill into the plate to create an OD of 15 - 16mm then with my setting snap i know i need an 11mm tail on the rivet (after its come through the armour that is)   http://www.ebay.co.uk/itm/16-5mm-Cob...ht_1797wt_1270 hope this helps matey Richie
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration). 
|
|
|
Threaded Mode