Help needed with details of the steel work behind and under front armour
 

Can someone with an un molested carrier, take some photos for me to show the details of the steel work behind and under the left side front armour, where it goes around the corner and underneath. Photos of the drivers side would help as well. I wish to see how the angle iron going foward meets the steel work at the bottom of the front armour.
The Bolt in the first picture would hold the front guard on.
The second picture shows (arrow) where the detail would be that I require. The hole the headlight wiring goes through should help you to orientate.

While we are here, does anyone know what the four circled factory rivets would otherwise have located? The extinguisher bracket goes to the left.

Lynn, I will get you some pics this week, those 4 blanked holes are for the boys anti tank rifle breech/butt support.

kev.

Lynn. this part on my carrier is original so here you go, the angle bar is shamfered off matey see below some older pics of my carrier....cant recall who else had asked for these details but nevertheless the pics were taken and retained hahahaha

http://img.photobucket.com/albums/v4...t/IMG_0655.jpg

http://img.photobucket.com/albums/v4...t/IMG_0656.jpg

let me know if you need measurements too

looking at the bit you have put on your track guard its been cut down a wee bit too much, needs to run flush with the inside of the lower tub wall, nothing a weld could not fix, or cut the next length of angle bar with with some extra material on ;)

nice rivets on yer floor / bulkhead by the way buddy

Richard
 

Thanks for that, Now I would like to see from underneath looking up.

Have you any pics of the other side?

What did you do your countersinking with?

Pic = a few more rivets

will quickly run out to the garage now and photograph before work...two tics

right. here are some pics from the underside hope they are ok
http://img.photobucket.com/albums/v4...t/IMG_0658.jpg
http://img.photobucket.com/albums/v4...t/IMG_0657.jpg


the countersink cutter i used was a Maykestag cobalt cutter 16.5 x 90 i use a slow speed drill and drill into the plate to create an OD of 15 - 16mm then with my setting snap i know i need an 11mm tail on the rivet (after its come through the armour that is)

http://img.photobucket.com/albums/v4...t/IMG_0660.jpg
http://img.photobucket.com/albums/v4...t/IMG_0659.jpg

http://www.ebay.co.uk/itm/16-5mm-Cob...ht_1797wt_1270

hope this helps matey

Richie

Details
 

Lynn, you wrote (paraphrased):

I wish to see how the angle iron going forward meets the steel work at the bottom of the front armour.
The bolt in the first picture would hold the front guard on.
The second picture shows (arrow) where the detail would be that I require. The hole the headlight wiring goes through should help you.


Here are your two images along with what I hope is the information you have requested. You will see the holes open where the mounting bolts that hold the Gunner side fender are currently removed.

Continuing
 

More pics of that corner and below:

Michael and Richard
 

Thank you very much for your help. That is exactly what I was after. :note: :note: