MLU FORUM  

Go Back   MLU FORUM > MILITARY VEHICLES > The Restoration Forum

Notices

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 13-04-11, 19:41
Alex Blair (RIP) Alex Blair (RIP) is offline
"Mr. Manual", sadly no longer with us
 
Join Date: Feb 2003
Location: Ottawa ,Canada
Posts: 2,916
Default Casting flaw..

Quote:
Originally Posted by Bob Carriere View Post
While doing the valve adjustement good old eagle eye Grant noticed a crack or cut on top of one of the valve rocker...... see picture below..... came as a total surprise.... when examined closer it is almost like a hacksaw cut rather than a crack.... and this rocker arm assembly was purchased totally rebuilt. It is running good right now but has me worried. all the valve push rods are turning properly and oil drippes out quite nicely.

Should I worry and replace it......??

Being a hoarder... I mean a well prepared boyscout ready for any eventuality I happen to have a spare fully rebuilt rocker arm assembly curtesy of EBay so doign a swap is quite feasible...... not sure yet.

I welcome your comments / suggestions.


Bob

Hi Bob..
It looks like a casting flaw to me and agree with Phil..run it..
__________________
Alex Blair
:remember :support :drunk:
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +2. The time now is 06:52.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © Maple Leaf Up, 2003-2016