|
|
#1
22-05-11, 15:36
|
||||
|
||||
radiator overflow brass elbow.
Hi, Has anyone got a spare CTL 7119 which is the cast brass radiator overflow elbow, (illustation 25 of the FUC-03).
Ben, I guess these would be easy to cast?. kevin.
__________________
2pdr Tank Hunter Universal Carrier 1942 registered 11/11/2008. 3" Mortar Universal Carrier 1943 registered 06/06/2009. 1941 Standard Mk1 stowage Carrier, Caunter camo. 1941 Standard Mk1 stowage Carrier, light stone. 10 cwt wartime mortar trailer. 1943 Mk2 Daimler Dingo. 1943 Willys MB. 1936 Vickers MG carrier No1 Mk1 CMM 985. 
|
|
#2
22-05-11, 17:43
|
||||
|
||||
|
have not got my parts book to hand... is this the elbow that bolts to the inside on the engine cover ?
__________________
is mos redintegro __5th Div___46th Div__ 1942 Ford Universal Carrier No.3 MkI* Lower Hull No. 10131 War Department CT54508 (SOLD) 1944 Ford Universal Carrier MkII* (under restoration). 1944 Morris C8 radio body (under restoration).
|
|
#3
22-05-11, 17:58
|
||||
|
||||
|
hi rich, yes thats the one. When you have finished making the convoy light holder i will let you have Rob's address so you can post it back to him.
cheers kevin.
__________________
2pdr Tank Hunter Universal Carrier 1942 registered 11/11/2008. 3" Mortar Universal Carrier 1943 registered 06/06/2009. 1941 Standard Mk1 stowage Carrier, Caunter camo. 1941 Standard Mk1 stowage Carrier, light stone. 10 cwt wartime mortar trailer. 1943 Mk2 Daimler Dingo. 1943 Willys MB. 1936 Vickers MG carrier No1 Mk1 CMM 985.
|
|
#4
22-05-11, 20:27
|
|||
|
|||
|
Kevin
I have one, no spare, sorry. It would be a cast part. The square part is the block to allow the part to be clamped and the holes to be drilled during manufacture. The two issues are.... using it as a pattern means the new part will be a little smaller this may be an issue as the threaded area will need filling and material adding to allow for shrinkage. Making a new pattern for casting is no problem but does involve a cost to produce. Both options require a set up cost to cast, around £40 plus a cost per part £10 (approx) Then the parts need to be machined. If you can get a few folks that need one together you can share the tooling and set up costs. I'm happy to help if i can. All the best Ben
|
|
#5
28-05-11, 04:58
|
||||
|
||||
|
Hmmmmmmm.......!
Hi Kevin,
I will go out to the shed this weekend and dig through the boxes,I know I had one as a spare,will contact you if I find it. Derk.
__________________
1942 Ford universal carrier Mk 1 1943 Ford 60 cwt long CMP ambulance 1943 Ford GPW 1/4 ton stretcher jeep 1943 Bantam T-3 1/4 ton trailer BSA folding airborne bicycle ser#R5325 (early)
|
 |
|
|
Linear Mode
