Mk1 Universal Carrier found

[aj.lec]

Hi tony
If it is your project and you get stuck I have a english built fordson 21 stud
v8 complete sitting in the shed .Havent tried to start it but it looks like it would . About the right vintage too. (if its compatable ) there is a picture of it in cab 12 thread

[Rob Beale]

This pic shows the set up with the cast extension on the rear axle protuding forward, and the round collar on the back of the gearbox mating to it.

I notice there is no gear on your gearbox outbox shaft - this fits to a matching female gear on the axle pinion.

The brake backing plates have a flange that bolts to the rear edge of the hull side plates, supporting the ends of the axle.

Rob

[Tony Smith]

Originally Posted by Rob Beale

This pic shows the set up with the cast extension on the rear axle protuding forward, and the round collar on the back of the gearbox mating to it.

I notice there is no gear on your gearbox outbox shaft - this fits to a matching female gear on the axle pinion.

Rob

A Carrier rear axle assembly has been found, but as Rob has said, we're now in need of the dog gear that goes on the output of the gearbox and meshes inside the splines of the gear on the diff pinion. With 6 internal splines and 16 external teeth, would this have used a gear from in the gearbox, namely the sliding 1st-Rev gear?

[Lynn Eades]

This is what you want. No it's not the same as a gearbox internal gear.

[aj.lec]

If you cant locate an original there is a place called maspro engineering in condobolin ph no. 68953913 that can make almost any gear to whatever spec you need (even worm gears )
They do a very good job
maybe not the cheapest option though