Reference: Plans How to build a tool box for a CMP truck

[Mike Timoshyk]

Hi Phil,

Thanks for the hint. Much appreciated.

Well another day and a little more progress. I managed to get the top plate finished with the curved piece welded in. Also installed the partition and prepared the internal support piece. That will go in tomorrow and I will try not to change my mind on which piece of the puzzle I will work on. I said I would be doing the wierd angle bits but never got a round too-it. Have to go to Princess Auto for one of those. In any case I believe I am on schedule. Oh by the way for those with the big dump yesterday...it is sunny here in Windsor.....FINALLY. Goenn fer a Timmy's now...may head back to the garage later for a glass of red....and survey tomorrow's work.

for now

Mike in Windsor Ontario

[Mike Timoshyk]

Well it is Day 7 and I am just about finished the big stuff. Next will be welding the top on and attaching some mounting plates. Then I will concentrate on the doors. I have primed the inside of the box and will put a couple of coats of paint on before I weld the top on then I will hit it a final time when everything is in place. Got the wierd angle done....did a template first to ensure I didn't have to cut 3 or 4 times before getting it right.

This will be it for a couple of days as I have a couple items on my dance card for the next few days.

Cheers for now

Mike in Windsor

Bob...all bookings have been made, should I bring my snowshoes or pray for the big thaw?

[Bob Carriere]

If it starts melting we will all need canoes.....

Nice job on the box..... been following each chapter has it unfolds.....

Bob