2008 at the Hammond Barn

[Bob Carriere]

Nice Sunday at the barn....... but wasted a whole 7 hours of fiddling.

After measuring and remeasuring I finally got the guts to cut a new hole in the floor to mount the E brake for the winch. We even dug out an old CMP seat to make sure we had enough clearance...... man it's a tight fit.

So Grant gave me hand removing the floor...again.... and cutting and grinding and filing. Once the top handle bracket was installed I fitted the bell crank underneath the floor..... and voila a job well done........

We re-isntalled the floor for a fitting.....KRAP.... the vertical brake rod that goes through the floor is directly above the E brake rod to the back of the transfer case. We measured again and it will need to be redone..... top bracket can stay in place but the rectangular hole for the rod will need to move over by a 1/2 inch and the bell crank underneath removed ....bolt holes welded shut and grinded and re isntalled about 1 inch to the left.......

Guess what I will be doing next weekend...... on the plus side I am now good at welding bolt holes shut and grinding to hide the evidence.... and I can now install the floor in my sleep.....

Will get it right yet!!!!!

On a more productive note....... thanks for a nice time at Gracies Saturday night....... but now all the pretty girls think I'm 75..... wonder if you get a bigger bar discount after 75...???

While doing my greasy CMP stuff Joyce was up at the wee hours to practice with her new camera/lens that Santee Clause got her...... her is a sample of her owling pictures......

Bob