WANTED Tri-Master roof ventillator

[gordon]

You might want to scroll through this thread;

http://forum.ww2dodge.com/viewtopic.php?f=10&t=2045
and see if you recognise anything desiarable. Closer to you - at least you could walk there but you'd have tired feet - warmth might make a change though.

I've got pretty much all the stuff for the railer, and of course the trailer is done bar wiring it to the truck, though like you some of the railer stuff is on the wrong side of the Atlantic, in this case the seats and floor crossbars.

The chassis is altered, and the military rear fuel tank fitted, the rear set of rail gear is mounted and slung, though mounting brackets need to come off for final reinforcement. I'm working my way forward, repairing the body lower sides and internal floor mounting edges, plus mounting the military spare wheel carrier for the side mount spare. I have the 'right' engine for it in stock, though it needs a rebuild.

The one engineering point I can't get past (yet) is mounting the winch. I have the MU Braden winch, and chassis extensions, but if I mount the winch chassis extensions and winch at the front AND have the rail gear on the front bumper it'll stick out about four feet in front of the original grille line. I've even considered mounting the winch in the centre of the vehicle, but of course I have to put the 4 x 4 transfer case and shafts there so no go.

By the time I've fixed the rest I should have worked it out. Worst case the winch will stay on the shelf and I'll just use the hand winch that's already on the trailer.