|
|
#11
24-08-07, 02:32
|
||||
|
||||
Careful!
Brad, I note that the brass fittings have been sandblasted. I am sure that they will not be blasted again in its lifetime, but you should take extra care and wrap any remaining brass to prevent the overly powerful erosion caused by sandblasting. As well, the elevation arcs and other machined steel should be protected to prevent the introduction of gear "slop".
I hope I am preaching to the choir here...amazing progress. On another note, how do you post two or more photos into a reply???
__________________
RHC Why is it that when you have the $$, you don't have the time, and when you have the time you don't have the $$? 
|
|
|
Threaded Mode