|
|
#14
14-02-05, 14:20
|
|||
|
|||
LAAT Rear Seats
Hi Rob,
Aprox 1" tack welds were used to secure the seat base in position on either side. Approx height being 2", at an angle of 85 degrees. The lower forward edge is also tacked in four roughly equally spaced welds, these welds being slightly longer at 1 1/2". My seat bases were made in two units, an L shaped section, firstly welded to the top of the wheelbox and the top section then welded to it. The seat bases are full width and length of the wheel box Hope this helps Cheers Keith 
|
|
|
Threaded Mode