MLU FORUM  

Go Back   MLU FORUM > MILITARY VEHICLES > The Softskin Forum

Notices

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #11  
Old 02-04-07, 06:28
Bob Moseley (RIP)'s Avatar
Bob Moseley (RIP) Bob Moseley (RIP) is offline
RIP
 
Join Date: Feb 2003
Location: Adelaide, South Australia
Posts: 2,620
Default Rob's Rear Axle Assembly

Hi all
Sitting down with Pedr and the MB-F1 manual the other day we have come to the conclusion that Rob's assembly is Ford. Furthermore I am now of the opinion that this assembly was the one utilised on the Chevrolet half-track. In any event that is what I am going to incorporate into Phoenix. As for the flange, possibly it was changed to accommodate the flange on the Chevrolet drive shaft combined with the fact that a universal joint would not have been required given that everything at the rear would be rigid instead of being flexible due to the rear springs.

Again with Pedr's assistance, I have also been able to interpret a high resolution image and have determined the probable design of the sub-frame assembly holding the double and single track bogies.

Bob
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +2. The time now is 17:39.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © Maple Leaf Up, 2003-2016