The toolbox is made up of flat or simple bent pieces of quite heavy sheet, welded together with full length seams. The hinges (4) look to be regular door hinges, welded on. The latch fitting on the side of the box is riveted in place but the hasp on the lid is attached by a single machine screw, possibly a later replacement? As Bob commented earlier, the holders inside fit a 2 gal POW can, but might have been meant for something else as well. Bob says the box was secured to the frame by "j" bolts through the holes in the toolbox base.
|
05-09-06, 02:36
Hybrid Mode
