|
|
#6
12-02-06, 16:04
|
|||
|
|||
Re: Drilling big hole through steel plate
Quote:
Get your self a Vari-bit...They work like a damn.. If you can use a drill press that is best..go slow and use Ridgid cutting oil..The dark stuff.. You can probably get both at a good plumbing wholesaler...Any of the trades guys can get them wholesale for you... They are expensive but I have been using one ,the same one for 10 years at least..It will handle 1/4" plate with ease.. Like this.. http://www.lenoxsaw.com/varibit.htm
__________________
Alex Blair :remember :support :drunk: 
|
|
|
Threaded Mode