|
|
#4
16-06-05, 05:39
|
||||
|
||||
That's a useful pic Phil. I, too, have been wondering what the rear bench seat for the HUP looks like - is that the one with the two-way back rest to fit in the tubes?
Do you have the rear-corner jumps seats as well? I don't know what the look likeither. I had a look at a HUP a few weeks back that had a bench seat in the right location, but it was some latter-day car seat, and the installation fittings did not look original, but cobbled up - is there some sort of tubular fitting facing forward in the centre of the floor? I will review my snaps to compare later.
__________________
Member: Prairie Command, Ex-Military Land Rover Association 2110, MVPA 29055 ’45 Chevrolet C8A CMP HUP “Staff Car ”, ’82 Land Rover Series III, 109" ex-MoD, ’80 Honda CX500D, ’48 Ferguson TE20 
|
|
|
Threaded Mode