Otter LRC CM4647296 comes home

[Jordan Baker]

Turret basket seat getting some rebuilding love. The original seat pan and back rest frame had taken some heavy rusting due to the open top of the turret. Initially I was going to weld up all the rust holes in the tray. However after looking it over again I decided to replace the seat tray. This involved cutting off part of the frame mounts and then using the original angle iron brackets from the Otter seat. The Otter also had a third lift the dot stud along the front of the seat. One had to be removed from the back of the seat and I soldered it in place at the front. The seat pan also needed 8 holes drilled in for the turret basket and Bren magazine parts to bolt in place.