|
|
#11
27-11-22, 20:44
|
|||
|
|||
Rob,
The tops of both fenderwells are completely flat with no ribs, and are identical. The edges are all rounded and look to be factory stamped as a complete wheelwell piece. There is 1 hole on the top rear that allows water to drain down. On both fenderwells, there are no dents. All of the edges were welded to the main body tub and tub floor. The welds do not look like an amateur did it, but by someone who knew how to weld did it. Richard 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| M38A1CDN2 rear light | Retsarge | Post-war Military Vehicles | 2 | 04-11-22 00:13 |
| MkI* U.C. (Canadian) rear panel holes | Lynn Eades | The Armour Forum | 12 | 30-09-18 04:09 |
| Iltis rear quarter panel restoration question | Stuart Fedak | The Restoration Forum | 6 | 09-09-12 22:37 |
| For Sale: Brand New Left rear tail light assmebly for M series | Casey B | For Sale Or Wanted | 0 | 15-05-12 05:56 |
| M38A1CDN2 vs CDN3 rear axle ass'y | chris vickery | Post-war Military Vehicles | 6 | 12-08-11 16:12 |
Threaded Mode