Making an electrolysis cleaning tank. Arm & Hammer Washing Soda was the detergent option as commonly recommended in several YouTube videos. We found a cleaning cycle of upto x20 hours is all that was needed, although I did carry out a longer cycle on the follow up 2nd dip. Around 20A power draw was observed during the initial clean but it dropped significantly across the duration of each cycle. I'm convinced that adding a uniform layout of anodes which covered all areas of the drum definitely paid off. The engine block was supported on wooden blocks in the base of the drum. Core plugs were removed to allow an improved circulatory flow & we occasionally used compressed air through a blow gun aimed directly through the water jackets. Results surpassed expectations.
Last edited by Craig W; 03-11-21 at 01:48.
|
02-11-21, 23:09
Similar Threads
Threaded Mode