|
|
|
|
#1
29-07-21, 22:56
|
|||
|
|||
F-60L Spare wheel holder
Hi Ivo,
Great job done there! Slightly different design to my Australian F-15A wheel holder bracket. Then again, the wheel holder is also different to Canadian ones. Mine is actually made from two pieces of 1/8" steel plate spot welded together. The spots are visible in the photo. I am hoping mine is original and not a later fabrication. If it is, at least it was well done and looks like another one I have seen. Even rivetted to the chassis as per original- nice. Mine should be too but obviously the brackets were donors from another vehicle hence bolted on. Cheers,
__________________
F15-A 1942 Battery Staff Jacques Reed 
|
|
#2
30-07-21, 16:20
|
|||
|
|||
|
Hi. These are not rivets but tear-off nuts, then ground into a cone.
Quote:
|
|
#3
31-07-21, 00:12
|
|||
|
|||
|
F-60L Spare wheel holder- chassis brackets
Hi Ivo,
Very effective! Could have never guessed they were not rivets. Cheers,
__________________
F15-A 1942 Battery Staff Jacques Reed
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Reference: CMP tool box and spare tire holder plans | George McKenzie | The Restoration Forum | 37 | 25-12-22 14:30 |
| Wheel cylinder for F60L | serge | The Restoration Forum | 3 | 07-03-14 21:01 |
| Spare wheel mount | Brad Mills | The Carrier Forum | 0 | 28-06-09 17:31 |
| SPARE WHEEL DRAWINGS FOR jim | Mike K | The Softskin Forum | 3 | 02-06-09 19:10 |
| Vickers spare barrel holder | ron | The Carrier Forum | 11 | 28-05-09 17:08 |
Hybrid Mode
