![]() |
#8
|
|||
|
|||
![]()
Thanks for the replies.
Remember this was a new m/cylinder that was working fine since installation circa 2 years ago and before I replaced the switch, refilled and bled the system, so I doubt it has the wrong spring. I've checked the brake pedal freeplay, lowered the fluid level in the cylinder, checked the tightness of the end bolt and changed the pressure switch yet again. No change. Press the pedal, and upon release, the brake lamp 'blips' off as the pedal recovers, but then remains on for a minute or so. Can't think of what to do next. B****y annoying... Mike |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
A silly Jeep question | Tony Smith | The Sergeants' Mess | 47 | 29-08-19 01:11 |
Jeep unit markings question | Jason Ginn | The Softskin Forum | 9 | 24-02-17 17:14 |
M38A1 Jeep 4x4 truck Wiper motor question | Casey B | Post-war Military Vehicles | 2 | 27-09-11 19:28 |
Jeep Question | Noel Burgess | The Softskin Forum | 12 | 10-11-10 17:33 |
How many can you fit on a Jeep ? | Mike K | The Softskin Forum | 4 | 29-06-07 18:36 |