|
|
|
|
#1
23-01-21, 02:31
|
|||
|
|||
The most thorough windshield washer thread available. I should note that these are covid times and some of us may have extra time!
Item number 4 is a hard plastic grommet, I assume intended for the large diameter suction hose as it passes through the firewall. Item number 6 is a plastic debris screen/ strainer. Also of note is that the inlet suction hose is a larger diameter than the outlet pressure hose I have attached a mock up of the assembled parts. 
|
|
#2
25-01-21, 19:10
|
|||
|
|||
|
windshield wiper fluid bottle
I have both the bag and the bottle on my M38a1.
My M38A1 was initially at Petawawa, then after it was rebuild in Montreal, it was sent to Kingston. Thanks Eric
__________________
Collecting data on the WW2 Canadian jeep and trailer. Serial, WD Numbers etc.
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Info needed: Parts Washer | chris vickery | The Restoration Forum | 8 | 04-01-21 02:03 |
| CFTO M38A1 CDN2 and M100 trailer + Camo paint pattern | derk derin | Post-war Military Vehicles | 5 | 20-05-10 13:50 |
| CFTO on wirecutters for M38A1 CDN 2+3/M151A2 | derk derin | Post-war Military Vehicles | 14 | 18-05-10 08:15 |
| CFTO on SMP tire pressure | derk derin | Post-war Military Vehicles | 3 | 11-05-10 08:29 |
| M38A1 CDN3 windshield wiper motors | Jon Skagfeld | Post-war Military Vehicles | 3 | 05-05-10 05:30 |
Hybrid Mode
