|
|
#9
29-09-20, 18:49
|
||||
|
||||
I climbed into the Otter today and took of a picture of the rear of the oil gauge. It has the larger tube size and long SAE fitting. The rest of the line is also larger then 1/8”. I’m wondering if there was a change that wasn’t reflected in the parts manual.
Some close up of the fittings from my Cab13. I realize the gauge is the later style but using to show the other type of fitting on the back side.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pressure lantern | Mike K | WW2 Military History & Equipment | 24 | 10-06-18 23:37 |
| Oil pressure Iltis | Wout Jansen | Post-war Military Vehicles | 0 | 24-08-17 10:00 |
| LP2 thread size needed | Craig Keown | The Carrier Forum | 2 | 14-07-16 08:34 |
| Forgotten.... What thread size are head studs into the block ? | RichardT10829 | The Carrier Forum | 11 | 05-02-14 08:02 |
| Help - 216 no oil pressure! | harrygrey382 | The Softskin Forum | 16 | 12-07-13 09:01 |
Threaded Mode