|
|
#10
13-08-20, 23:37
|
|||
|
|||
Any small-scale can maker
If you wisk that info down to your local sheet metal shop, they should be able to provide a quotation to manufacture a small quantity.
In Australia, I'd be talking with Cecil & Co in Bayswater, Victoria, who have the necessary rollers, Philidelphia seamer, bottom edge rollers, and soldering setup - the only difficulty I can see is the pressed dimple in the top. It is a straight-forward can-making process with a few quirks in terms of soldering in the tubes and the pressed dimple in the top. Mike 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Coolant recovery bottle on dash? | Phil Waterman | The Restoration Forum | 0 | 31-07-17 21:38 |
| Coolant Recover Tank Not Working | Phil Waterman | The Restoration Forum | 3 | 28-05-15 01:58 |
| 12 volt condensor | Little Jo | The Restoration Forum | 23 | 25-06-12 09:44 |
| Chevy Condensor Can wanted | Neil Ashley | The Restoration Forum | 5 | 28-04-05 21:24 |
| Coolant Heater | JD Baillie | Post-war Military Vehicles | 10 | 23-12-03 17:30 |
Threaded Mode