Lynx1 No.23 Home!

[Peter Duggan]

Harry,
The Spare Parts Manual for the Lynx 11 only lists two brackets for the steering gear, 3678 and 3925, which both have the C19SR prefix, which I interpret as being the same as the first marks of the Lynx. The lower steering gear shaft on my Lynx is 3" from the lower glacis plate.

Hope this helps, Peter

IMG_2291.jpg IMG_2289.jpg IMG_2288.jpg

[Harry Moon]

so I'm at that dimension right now so all is good on my end.

[Harry Moon]

So I’ve been spending time sorting out all kinds of little things with this communist experience. One of the things that I attended to was getting the speedometer to work and why I broke two cables. Putting my mind to it with the engine in the back the transfer case runs opposite of the direction in a F15a the middle shaft is rotating in the opposite direction. So as the transfer case I have was rebuilt with parts from a 15 cwt the speedometer gear was for the other direction. LWDPARTS has the correct Speedo gear as per the Lynx parts book so I’ll get it sorted out. Of note is that with the driveshafts turning the opposite direction the axles are inverted. Something I never would have thought of and for the guy that found the stripped hull in Italy he needs to be very careful in going about modifying a set of axles from an F15A.

[Andrew Rowe]

Hi Harry, the main two different things when you use a C15A ,( C8A ) single speed transfer case to convert to a Lynx is the input shaft is different, and can interchange out. The speedo drive gear that goes on the intermediate shaft is reversed cut in the opposite direction ,( drive gear ) so that has to change out if using a standard transfer case, and yes the driven gear comes in MK1 and MK2 , because of the change in diff ratio's , it is about a tooth difference from memory, also check speedo end turns freely , as this can be a source for braking a shaft cable if it has not been used for a while. I still have those other parts here for you as well, must get organised, Cheers Andrew.

[Andrew Rowe]

The steering bracket 3925 is the large main casting that bolts the steering box to the chassis, at the lower level, and is the same heavy casting for both model Lynx's. The small casting 3678, is the upper one from hull to support outer steering column. This can come in two slightly different castings, just one being slightly more of a heavier casting than the other, they both have the same cast number imprinted in them (C19SR 3678), Cheers Andrew.