|
|
|
|
#1
28-06-20, 19:16
|
|||
|
|||
Ignition switch
There were a variety of sockets used by the dealer to remove the bezel. I think if your truck has dimples in the bezel it would probably be threaded. Many people just used pliers to remove them. If you are careful and it’s not too tight it would come undone without damaging it. I have twisted the switch from behind the dash to break it loose and then unscrewed the bezel. I have seen some really old ones with a set screw holding the ring on also. It probably depends on the year.
|
|
#2
29-06-20, 22:13
|
||||
|
||||
|
1939 Chevrolet VC (1.5 ton) Electrolock...
Hello Paul,
I will look for a very small spanner wrench about 1.5" to try to turn the bezel and also try your trick about carefully twisting the lock from behind to get it going... Thank you for the advice.
|
|
#3
06-02-21, 01:45
|
||||
|
||||
|
1939 Chevrolet VC (1.5 ton) Electrolock...
After some waiting, I finally came across the correct electrolock for the truck, GM 1126278 equivalent...
|
 |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Rear Cargo Bed 1939 Chevrolet WA... | Philippe Jeanneau | The Softskin Forum | 10 | 28-10-22 10:42 |
| 1939 Chevrolet VC (1.5 ton) Truck Generator Options... | Philippe Jeanneau | The Softskin Forum | 5 | 26-06-20 15:49 |
| For Sale: 1939 drawings for truck box. original | peter simundson | For Sale Or Wanted | 0 | 28-08-17 16:26 |
| 1939 to 1946 Chevrolet or GMC truck | M38CDNBill | For Sale Or Wanted | 1 | 26-10-10 21:47 |
| 1939 F8 4 x 2 8 cwt Truck | Jim Price | The Softskin Forum | 12 | 09-04-08 12:15 |
Hybrid Mode
