Ford Crankshaft pulley needed.

[Michael R.]

Originally Posted by Harry Moon

I don't think there is a balancer on the hub I'm looking for and only a single pulley. In addition has anyone come across this set up before?

Run your parts book numbers and consider looking for the same water resistant shielded ignition assembly in the Ford Canada models of the Windsor carrier.

[Peter Duggan]

Harry,

I was very fortunate to find an NOS setup including braided cables which David Good installed when he rebuilt my engine. I have had the points since converted to a Pertronix kit. The shielding boxes were great for hiding the new configuration. Ross's suggestion that the same components were used on the Windsor carrier certainly opens up the potential parts sources.

Peter


IMG_0362.jpg

IMG_0366.jpg

IMG_0367.jpg