MLU FORUM  

Go Back   MLU FORUM > MILITARY VEHICLES > The Restoration Forum

Notices

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #32  
Old 15-02-20, 16:00
David Dunlop David Dunlop is offline
Registered User
 
Join Date: Feb 2006
Location: Winnipeg, MB, Canada
Posts: 3,599
Default

Darryl.

Do you have a bare splined shaft available the gen pulley will fit on?

If so, you could centre the pulley on the shaft and place the assembly between two hard level surfaces (steel or glass is best) and see if the assembly stays where you placed it or rolls to a different point and stops. If the latter, the assembly is out of balance and has stopped where the most weight is at the bottom.

Seems odd that somebody milled out some metal between the fins on that pulley on the ‘short side’ of the shaft hole. I would have thought that would have made the ‘long side’ even heavier.

David
Reply With Quote
 


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump

Similar Threads
Thread Thread Starter Forum Replies Last Post
Ford V8 engine number - ID? Hanno Spoelstra The Softskin Forum 0 08-04-18 15:42
Ford contract number Hendrik van Oorspronk The Softskin Forum 2 14-09-17 21:00
ford t16 chassis number tracing Joe Bowen The Carrier Forum 6 03-11-16 12:37
Contract number for Ford F15A Chris Daines The Softskin Forum 0 01-12-15 14:44
Ford engine number decoder Keith Webb The Softskin Forum 5 24-05-07 17:54


All times are GMT +2. The time now is 01:54.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © Maple Leaf Up, 2003-2016