|
|
#12
15-10-19, 22:14
|
||||
|
||||
Waterman Special CMP Tool Co.
Thanks for all the tips and hints, guys. The tool I borrow was made up from an old screwdriver. Angles were not entirely right and I could not put enough leverage on it.
It does not help the cylinders may be seized. I will be soaking them again in WD40 and copy Phil's tool. I have a 10 mm wide cold chisel, some 25 cm long, which I reckon would fold up nicely along Phil's dimensions - if you could please post the dimensions, Phil? If the brakes are rusted solid and I cannot back off the brakes, I guess I have no choice but to pull the hub + brake drum with force? Hanno
__________________
Regards, Hanno -------------------------- 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| T16 Rear Tool box | andrew honychurch | The Carrier Forum | 0 | 19-04-12 20:48 |
| Shaft adjustment on rear axle of m38a1 | serge | Post-war Military Vehicles | 2 | 06-08-10 09:23 |
| AIF Bren gun carrier track adjustment tool | Ausmick | For Sale Or Wanted | 0 | 13-03-10 22:04 |
| Dummie’s guide to carrier steering and brake adjustment please | Big D | The Carrier Forum | 42 | 31-05-09 11:19 |
| Rear Tool holders | kevin powles | The Carrier Forum | 4 | 25-05-09 10:27 |
Threaded Mode