|
|
#11
02-06-19, 21:12
|
||||
|
||||
The next problem was bolting the final drives to the chassis as I had cut the original studs off of the castings. There are six 1/2" UNC threaded holes already in the front of the castings that I can utilise but I need some in the flange area. The answer was to drill five new holes for M16 bolts and then weld bosses on the rear of the flange so that the flange bolt securely on to the chassis. The output shaft was then reassembled into the casting so that I can position the final drive housing onto the chassis and drill all the attaching holes.
That's all for now folks, Jon
__________________
1950 Land Rover series 1 1967 Land Rover series 2A LWB 1986 Land Rover series 3 SWB 1938 DKW SB200 1944 DKW NZ350-1 1967 Ural K750 sidecar outfit 1944 VW Kubelwagen KDF82 1942 Steyr 1500A 1944 Morris C8A 1943 Chevrolet CMP8A HUP? 194? Bedford QL 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Armour in the Rhineland | John McGillivray | The Armour Forum | 1 | 05-11-11 20:04 |
| Armour id needed | BSHEVLIN | The Armour Forum | 2 | 18-06-09 05:21 |
| Old Armour in service | matilda IIA | The Armour Forum | 19 | 11-03-09 12:11 |
| Armour i.d. | David_Hayward (RIP) | The Armour Forum | 8 | 14-09-07 11:27 |
| Tim Tam Ice Creams!! | David_Hayward (RIP) | The Sergeants' Mess | 2 | 23-09-05 04:08 |
Threaded Mode