Wanted: «*B*» Set antennae isolator wanted - repro OK

[David Dunlop]

Robert.

I notice in your first post, your B-Set Aerial Guard appears to be too low. It looks like it is resting on top of the square base plate of the B-Set Aerial mounting post.

If you lowered it there to service your broken aerial mount, that is OK.

However, if that low position is where you fitted the Guard, that is incorrect. The top clamping ring of the guard assembly should be just below the circular mounting plate on the bottom of the rubber B-Set Aerial Mount. This places the circular guard ring well above the top of the rubber mount, in a position where it can reduce damage to the aerial itself.

By the way, I didn’t see any buckets of Maple Syrup in the back of your Carrier. Is the sap not flowing yet?

David