|
|
#11
19-08-18, 03:32
|
|||
|
|||
A major milestone has been reached.
After a couple of individuals pointed out it is necessary to load the output Jones Socket on the ZE-11 and ZE-12 Supplies with an appropriate resistance in order to get the true output, I did the obvious. I reread the test instructions for these supplies. There they were. A 3000 Ohm resistor was needed to jump the two HT terminals and an 8 Ohm resistor across the LT terminals. The readings are taken across each resistor. And both readings dropped right into the stated specification range. Finally, with a fully operational Remote Supply I can now complete the cleaning and inspection stage of the Remote Receiver and see what it is up to. David 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Canadian staff car wireless: World War 2 Canadian R103 Receiver Demo | Mike K | The Wireless Forum | 5 | 24-07-16 15:20 |
| Found: CMP Wireless body project | Jim Burrill | For Sale Or Wanted | 7 | 05-04-15 00:02 |
| Canadian dehavilland mosquito restoration project | David Dunlop | WW2 Military History & Equipment | 9 | 10-07-14 00:51 |
| Canadian project | David Ellery | The Carrier Forum | 9 | 28-04-07 01:36 |
| FOR SALE/TRADE: 1944 CHOREHORSE PROJECT for Signal Corps Wireless Power Unit Project | Alain | For Sale Or Wanted | 1 | 21-02-07 00:11 |
Threaded Mode