|
|
#7
30-04-18, 20:25
|
|||
|
|||
Chevrolet hand crank
A couple of weeks ago, it was decided to replicate the Chevrolet hand crank. Bob had an original that matched dimensions found on stovebolt.com.
3/4" steel rod was cut to approximate length. Scrap pieces of electrical conduit were also cut to length. The conduit bits were then heated and beaten to form a partly closed end. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 2016 at the Hammond Barn | RHClarke | The Restoration Forum | 83 | 08-01-17 18:22 |
| 2015 at the Hammond Barn | RHClarke | The Restoration Forum | 113 | 31-12-15 21:00 |
| 2010 at the Hammond Barn | RHClarke | The Restoration Forum | 181 | 01-01-11 03:02 |
| 2009 at the Hammond Barn | RHClarke | The Restoration Forum | 322 | 02-01-10 16:05 |
| Hammond Barn Visit | Wpns 421 | The Softskin Forum | 1 | 15-12-09 03:17 |
Threaded Mode