For Sale: M8 armoured car bits and pieces for sale

[Big D]

Hi all,

I have some more parts left over from my M8 restoration and have updated what is left:

* Protectoscope box holder bolt. Working well. Asking $15 USD

* IN121 insulator. NOS. Asking $15 USD

* Cable, distributor to coil with conduit. Asking $20 USD.

* Cable with conduit. Asking $20 USD.

* Armored vehicle conduit. NOS with a tag which I can't make out the writing. 9 foot long. Asking $60 USD.

* Assorted conduit. Lengths are 24", 27" and 28". Not sure what they are from. Asking $30 USD for all three.

* Steel cable tubing. This goes between the rear terminal box and the taillight wiring. Asking $15 USD.

* NOS Circuit breakers for Generator. Asking $15 USD each

* Engine rubber mounts. Tidied up and in useable condition. $20 USD for both.

* Axle grease seals. Asking $4 USD each.

* Distributor. Complete with cap. No points or condenser. Asking $50 USD.

* .50 MG turret elevator mount. Complete with ammo can tray. Good condition. Asking $1500 USD.

* Throttle master cylinder. Missing internal piston. Asking $50 USD.

* Steel skirt for turret. About 600mm long. Ideal for turret repairs. Asking $20 USD.

* Latch for hull/hatch visor . Looks a little rough, but works. Asking $10 USD

* Instrument panel mount for circuit breakers. Asking $10 USD

* Throttle slave cylinder mount. A reasonable repro. Asking $5 USD

* Radio box – used. As fitted in the sponson. No lid. Will clean up okay. Asking $15 USD.

* Exhaust piece. One end missing but still has the heat shield. Asking $30 USD.

* Drag link. NOS. Asking $120 USD.

* Shock absorber mount. A little corroded and one of the mounting tabs is a little bent. Asking $10 USD.

* Transmission lever housing. Has cutaway top but otherwise in very good shape. Complete with levers and locking screws. Asking $100 USD.

* Fan tunnels for the radiator. New reproduction. $100 USD each.

* Brake backing plate. Will require some straightening. Asking $15 USD.

* Brake backing plate. Appears in good condition. Asking $30 USD.

* Brake slave cylinder caps. Will require restoration. Asking $10 USD for the adjustable end and $5 USD for the fixed end.

* Brake adjustment locking plate. Asking $5 USD.

* Brake shoe securing bolts with springs. Good condition. Asking $10 USD each.

* Sponson cover. French made. Rough but repairable. Asking $20 USD.

* 37mm rack part. Asking $10 USD.

* Transmission lever housing. Corrosion damage around the base. Asking $10 USD.

* Handbrake adjusting pin. A little bent but should straighten. Asking $5 USD.

* Turret traverse housing piece. A part of this where the handle would be has been cut away. Asking $5.

* Propellor shaft piece. Requires repair. Asking $10 USD.


Please PM if interested. Payment by Paypal is okay and prices exclude the ride there.