|
|
#11
10-02-18, 01:31
|
||||
|
||||
I had a centre to work with and made a centre in my rotating table to align them both with and then checked it with a centre point on the mill before I started cutting. It was certainly close enough for me. I also had to make a support while cutting which is just a couple of bearings roughly supported just for this particular job and it works well.
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Door Resto | Barry Churcher | The Restoration Forum | 13 | 15-05-22 16:36 |
| FAT cab 13 No 9 resto | Mrs Vampire | The Softskin Forum | 27 | 29-09-21 07:11 |
| C15A resto | harrygrey382 | The Restoration Forum | 9 | 08-06-15 10:40 |
| another CAN m37 resto | Steve Wilson | The Restoration Forum | 11 | 25-08-12 16:57 |
| m 37 resto in new brunswick | pauljboudreau | Post-war Military Vehicles | 118 | 07-03-11 23:29 |
Threaded Mode