Armour Dreams

[Jonathan Moore]

Evening all,


I have managed to finish the 9 remaining suspension arm shafts and associated components and the spring retention rollers, well that's what I am calling them. As I don't have any technical construction details of these, this is my version. The spring retainer rotates as the spring is flexed by the suspension arm, the unit consists of a shaft on a back plate and a housing. The housing contains an oil seal at the inner end, followed by a bearing, then a spacer followed by a second bearing. This is the pressed onto the shaft and held in place with a washer and a bolt. Another spacer is followed by a 3mm section o ring and an end cap, all held in place by a circlip. The last picture is an original unit. The original has an oil / grease point in the centre of the end cap, on my version this is just a dummy that can be unscrewed and replaced with a grease nipple so that the unit can be filled with grease on final assembly.





Jon