|
|
#6
26-11-17, 14:40
|
|||
|
|||
See posts:
Throttle leaf springs by George, http://mapleleafup.net/forums/showpo...07&postcount=5 Steering cam control rods by Lynn, http://mapleleafup.net/forums/showpo...65&postcount=1 (With regards the cam control rods, the length of the rod from tip of the thread to the center of the pin (long clevis end) is 687mm. this includes the 35mm of thread. This would be the total of CTL 2881 and CTL2882 (1941 parts book) if both were riveted together as one assembly (and any adjustment would be made at the small clevis end. This is here so that someone can make up their own rod assemblies using original clevises. I hope its all clear?) Last edited by Michael R.; 26-11-17 at 14:46. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Fixing a flat! | Harry Moon | The Restoration Forum | 15 | 10-07-12 05:37 |
| Flat front Bedford in 1961! | David_Hayward (RIP) | The Softskin Forum | 1 | 02-10-09 20:26 |
| Flat head parts wanted | Mike Timoshyk | The Restoration Forum | 3 | 06-07-07 10:35 |
| flat head problem | alleramilitaria | The Carrier Forum | 18 | 08-04-06 22:35 |
| Side or Flat V8 | Nigel Watson | The Softskin Forum | 7 | 29-10-05 06:42 |
Threaded Mode