|
|
#34
20-11-17, 09:29
|
|||
|
|||
To prepare for the seat base frame I had a piece of 2mm strip folded to the correct dimension. I ground a round edge on the top of the template to accommodate the curve of the strip of now angle. I was able to use the cross cavity to anchor clamps and supports to secure the angle and with a bit of heat worked the angle around the template. It puckered in the corner as is went which I expected and it was just a case of heating the pucker up and hammering it down.
__________________
1943 Willys MB Willys Trailer 1941 Fordson WOT 2H 1941 Fordson WOT 2H (Unrestored) 194? Fordson WOT 2D (Unrestored) 1939 Ford 1 ton utility (Undergoing restoration) 1940 Ford 1 ton utility (Unrestored) 1941 Ford 1 ton utility (Unrestored) BSA folding bicycle BSA folding bicycle 1941 Ford/Marmon Herrington 3A gun tractor 1941 Ford/Marmon Herrington 3 gun tractor (Unrestored) 1941 Diamond T 969 (Unrestored) Wiles Junior Cooker x 2 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1943 Morris Commercial C8 4x4 GS project | svdwal | The Restoration Forum | 25 | 13-07-15 19:54 |
| WW2 Collins transmitter FS | Mike K | For Sale Or Wanted | 0 | 16-09-11 03:34 |
| Civvy Tilly's | scale-modeller | The Softskin Forum | 10 | 31-01-11 00:38 |
| Morris-Commercial project | Mike K | The Restoration Forum | 12 | 18-11-10 01:02 |
| 41 morris project | alleramilitaria | The Softskin Forum | 37 | 26-07-09 07:04 |
Threaded Mode