|
|
#33
02-06-17, 04:23
|
||||
|
||||
Some assembly required. I was extra careful to ensure everything was lined up before tacking the parts into position. It is amazing how parts can appear to be lined up, you clamp and measure and then measure again only to find its out by 1/4" Re clamp and re measure and then weld.
For the table top, after careful study of the hole pattern, there is three sets of holes for the various WS carriers. Some of the holes are 3/8" diameter. I chose to drill most of them only to 1/4" for now. I figured its a lot easier to drill them larger down the road vs having them too big now.
__________________
Jordan Baker RHLI Museum, Otter LRC C15A-Wire3, 1944 Willys MB, 1942 10cwt Canadian trailer 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 1944 C-15A-Wire-5 Restoration | RichCam | The Restoration Forum | 706 | 18-05-23 02:43 |
| Sold: 1944 Chev C15A Wire-3 | Don Dingwall | For Sale Or Wanted | 11 | 02-04-15 23:26 |
| What was once 2, is now 1. (C15A-Wire-5) | RichCam | The Softskin Forum | 3 | 30-12-11 22:49 |
| photos needed for c15a wire 3 van body | jason meade | The Softskin Forum | 5 | 10-08-11 06:29 |
| Wire loom for C15A Cab13 | Jordan Baker | The Restoration Forum | 19 | 28-08-06 03:42 |
Threaded Mode