|
|
#29
18-04-17, 10:30
|
||||
|
||||
Thankyou Dave, I will use modern gasket material as the old ones were paper. I would think it should be very quite when running.
An interesting one came up today. As you can see by the photo, there are two of these lever stands that bolt to the side of the gearbox. They are tapered on 3 sides but straight on the other. I sat there for awhile and tried to think how can I do that on the lathe. Then it struck me. Any ideas? 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Door Resto | Barry Churcher | The Restoration Forum | 13 | 15-05-22 15:36 |
| FAT cab 13 No 9 resto | Mrs Vampire | The Softskin Forum | 27 | 29-09-21 06:11 |
| C15A resto | harrygrey382 | The Restoration Forum | 9 | 08-06-15 09:40 |
| another CAN m37 resto | Steve Wilson | The Restoration Forum | 11 | 25-08-12 15:57 |
| m 37 resto in new brunswick | pauljboudreau | Post-war Military Vehicles | 118 | 07-03-11 22:29 |
Threaded Mode