![]() |
|
#1
|
||||
|
||||
![]()
I am well documenting this project because of its rarity and have already taken a couple of hundred pics.
|
#2
|
|||
|
|||
![]()
What is the plan to disassemble the gearbox Colin? A thorough soak in something for a time first? Or does it just look worse than it is?
__________________
1943 Willys MB Willys Trailer 1941 Fordson WOT 2H 1941 Fordson WOT 2H (Unrestored) 194? Fordson WOT 2D (Unrestored) 1939 Ford 1 ton utility (Undergoing restoration) 1940 Ford 1 ton utility (Unrestored) 1941 Ford 1 ton utility (Unrestored) BSA folding bicycle BSA folding bicycle 1941 Ford/Marmon Herrington 3A gun tractor 1941 Ford/Marmon Herrington 3 gun tractor (Unrestored) 1941 Diamond T 969 (Unrestored) Wiles Junior Cooker x 2 |
#3
|
|||
|
|||
![]()
What type of alloy is the transmission case, Colin?
David |
#4
|
||||
|
||||
![]()
Yes jack, i'm in the process of getting it apart now and it only looks bad because it is bad
![]() It sure is an interesting little project. ![]() ![]() |
#5
|
|||
|
|||
![]()
Colin, is it possible there is a case laying around somewhere?
Are they special to this mark of tank or could hey have used the same gearbox in other Vickers Carden Loyd machines?
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... |
#6
|
||||
|
||||
![]()
Hi Lynn, as far as I know these boxes are only in the Vickers light tank and the odds of finding another exactly the same would be the old needle in a haystack scenario but I guess most things are possible. I think that if the gears were destroyed as well it would be a different story and by the end of today I should have it all apart. Then I can have a good look and make a better decision then. I might find that this one could be repaired which would be great so I'll keep my options open.
Colin |
#7
|
||||
|
||||
![]()
The pulldown is now complete and I don't think there is much chance of a rebuild. There's too much of it gone. It's mainly the bearing housings that would be of major concern to me. I will measure and draw each individual face for fabrication. One good thing is that I can use the original box to make the fabrication jig.
Colin. |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Door Resto | Barry Churcher | The Restoration Forum | 13 | 15-05-22 15:36 |
FAT cab 13 No 9 resto | Mrs Vampire | The Softskin Forum | 27 | 29-09-21 06:11 |
C15A resto | harrygrey382 | The Restoration Forum | 9 | 08-06-15 09:40 |
another CAN m37 resto | Steve Wilson | The Restoration Forum | 11 | 25-08-12 15:57 |
m 37 resto in new brunswick | pauljboudreau | Post-war Military Vehicles | 118 | 07-03-11 22:29 |