|
|
#34
05-03-17, 06:34
|
|||
|
|||
Pulled brake drums off yesterday . The left stem and spring Assy frozen solid , so I could not adjust the brakes have fixed that now , can some one show me a close up photo of the small pin that goes through the splined washer into the inside large nut that holds the drums and bearings onto the shaft my one was broken so not sure what the head looks like ? I can make new ones on my lathe , also the inside seal is no good . Is there a modern seal to suit if so does any one have the part number , I'm going to order some new bearing tomorrow ..
__________________
1944 GPW and Bantam trailer 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vic rail 2225 | colin jones | The Carrier Forum | 109 | 13-07-13 15:15 |
| My GM engine number when was it build?? | 8threcce | The Restoration Forum | 7 | 09-01-12 08:39 |
| Iltis carb re-build kit | servicepub (RIP) | Post-war Military Vehicles | 2 | 15-05-11 22:33 |
| How To Build A 2/5 Sherman Tank | T.J. | The Armour Forum | 1 | 16-01-08 11:17 |
| Pssst... want to build a gun tractor? | Keith Webb | The Softskin Forum | 12 | 16-07-04 00:13 |
Threaded Mode