|
|
#17
01-10-16, 02:40
|
|||
|
|||
I am at this point with my carrier and find I have a small gap at the top of the coupling housings.
I have tried insalling an extra thin washer under the pump on each side and as Rob previously mentioned, this just stops one from fitting a split pin into the mount bolt. I am going to install a set of (4) shim plates under the mount saddles to see if they bring the coupling into alignment. I put a 0-1 g cramp on the salvaged shims that I previously mentioned. They are a nominal 1/8" (0.125") thick. I am interested to hear from anyone who has heard of these in any publications and also from you Rob, about the training film.
__________________
Bluebell Carrier Armoured O.P. No1 Mk3 W. T84991 Carrier Bren No2.Mk.I. NewZealand Railways. NZR.6. Dodge WC55. 37mm Gun Motor Carriage M6 Jeep Mb #135668 So many questions.... Last edited by Lynn Eades; 01-10-16 at 23:04. 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wanted: carrier tow chain assy. | Lynn Eades | For Sale Or Wanted | 0 | 13-02-16 22:54 |
| For Sale: U/C Leather coupling | Andrew Rowe | For Sale Or Wanted | 3 | 03-02-16 05:51 |
| Sold: Horn button assy | Lynn Eades | For Sale Or Wanted | 6 | 30-08-13 02:29 |
| Wanted: carrier coupling | Euan McDonald | For Sale Or Wanted | 4 | 14-05-12 13:25 |
| NOS filterette assy, Willys MB | chris vickery | For Sale Or Wanted | 3 | 08-12-11 03:05 |
Threaded Mode