|
|
#32
24-07-16, 05:02
|
|||
|
|||
M8 restoration
Hi Lynn
Thanks for the reply. If you mean pulling the whole pinion assembly from the housing, yoke and all, then I have tried that as well. I would have thought that I could 'tap' it out from inside the axle housing but I got no movement on the pinion assembly that way either. I guess I am dealing with two bearing assemblies that are themselves very tight in the housing. Any bright ideas for doing this?
__________________
Cheers, Darryl Lennane 1943 Willys MB 1941 Willys MBT Trailer 1941 Australian LP2A Machine Gun Carrier 1943 White M3A1AOP Scout Car 1944 Ford M8 Armoured Car 1945 Ford M20 Armoured Car 
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Ford V8 engine number - ID? | Hanno Spoelstra | The Softskin Forum | 0 | 08-04-18 15:42 |
| Ford contract number | Hendrik van Oorspronk | The Softskin Forum | 2 | 14-09-17 21:00 |
| ford t16 chassis number tracing | Joe Bowen | The Carrier Forum | 6 | 03-11-16 12:37 |
| Contract number for Ford F15A | Chris Daines | The Softskin Forum | 0 | 01-12-15 14:44 |
| Ford engine number decoder | Keith Webb | The Softskin Forum | 5 | 24-05-07 17:54 |
Threaded Mode